A Revolutionary Cyclonic Screw is Born!

Gary Hollis is a licensed builder and has interest in all aspect of the building industry and for sometime had been concerned about the design of the traditional cyclonic assemblies available. The traditional products were unattractive and bulky and had the potential to cause problems with water ingress.

It was time for a design change!

During his many trips to Melbourne, Gary mentally re-designed the product and within a few days a prototype was designed based on good engineering practices. These prototypes were then tested by BHP Australia to evaluate the ability of the product to match the holding power of the more cumbersome 'traditional' products out in the market place.